HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Installing Command View SDM 33
Installing
Command View SDM
root 2592 2579 2 15:31:30 pts/tb 0:00 grep pfs
7 If the above processes are not running, execute the following commands,
/usr/sbin/pfs_mountd &
/usr/sbin/pfsd &
8 Mount the CD device file using the device file and directory from the
preceding steps.
For example:
pfs_mount -t rrip -o xlat=unix /dev/dsk/c2t2d0 /cdrom
9 Run swinstall using the appropriate command:
HP-UX 11.00
swinstall -s /cdrom/CommandViewSDM/hpux/
cvsdm_11_00_v109.depot
HP-UX 11.11
swinstall -s /cdrom/CommandViewSDM/hpux/
cvsdm_11_11_v109.depot
HP-UX 11.23 IA and HP-UX 11.23 PI on IA
swinstall -s /cdrom/CommandViewSDM/hpux/
cvsdm_IA_11_23_v109.depot
HP-UX 11.23 PI on PA
swinstall -s /cdrom/CommandViewSDM/hpux/
cvsdm_PA_11_23_v109.depot
Check the appropriate /cdrom/CommandViewSDM/hpux directory for the
complete version name of the depot file.
10 Highlight CMDVIEWSDM from the list, then Mark it for installation from the
Action menu. All required Command View components will be marked for
installation.
11 Start the installation by selecting Install from the Action menu. Complete the
information requested on the swinstall screens.
Note The installation process may determine that components
required by Command View SDM are aleady installed. In this
case, an error message may be displayed, but it can be ignored.
12 Once the software installation is complete, log out, then log back in to reset
the path.