HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

22 Product Description
Operating System Support (Native)
The Command View SDM software is supported on the following operating
systems. Because hosts running these operating systems can both access the
array and also manage the array using Command View SDM, these are
referred to as “native” operating systems.
■ HP-UX*
■ Windows 2000**
■ Windows Server***
■ Red Hat Linux Advanced Server****
*Command View SDM provides support for HP-UX 11.00, 11.11 (11i 32-bit),
11.23 (V2, Itanium), 11.23 PI on IA, and 11.23 PI on PA-RISC in a non-HP
OpenView environment. Command View SDM does not support HP-UX 11.20.
**Command View SDM provides support for Windows 2000 Server SP4 (32
bit) and Windows 2000 AS SP4 (32 bit).
***Command View SDM will now support Window Server 2003 (32-bit).
****Command View will support Red Hat Linux version is RHEL AS 3.0 with
Kernel version 2.4.21-9EL
Installation instructions for each operating system are included in Chapter 2.
Non-Native Supported Operating Systems
In addition to the native operating system listed above, the HP StorageWorks
Virtual Array products are also supported on the “non-native” operating
systems listed below. Hosts running these operating systems can access data
on the array; however, Command View SDM is not supported on them.
Consequently, array management must be done from a host running one of
the supported operating systems listed above.
■ Sun Solaris
■ IBM AIX