HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Command Line User Interface 139
Command Line User Interface
armmgr
Description
The armmgr command manages the configuration parameters of the array.
These settings control the operation of the entire array, consequently, every
LUN on the array will be affected by any changes made using this command.
This command also allows you to shutdown, restart, and reset the array.
Changing some of the array settings may require that the array be reset using
the -R option. The user will be prompted to initiate a reset if the modified
setting requires this action.
Note Several of the armmgr options are used to set the array Fibre
Channel arbitrated loop (FC-AL) operating parameters. These
parameters control the transfer of data between the host and
array and typically do not need to be changed. Before
changing a FC-AL setting, make sure you understand what effect
it will have on array operation. Selecting an incorrect setting
may make it impossible for the host to access the array.
Syntax
For all firmware versions:
armmgr {-a <on | off> |
-b {CreateLun | FwDownload | Security | Select | PassThru | HostPort} |
-c <FRULocation> |
-d |
-D <alias>} |
-f {on | off} |
-i {on | off} |
-J {SingleController | Secure | Normal | RestrictedNormal | HighPerformance}
-l <FRULocation> <value> |
-n <value> |
-p {start | disable}|
-r {on | off} |
-R [full | partial] |
-s {shut | start} |
-t <value> |
-w {on | off} |