HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Command Line User Interface 121
Command Line User Interface
Examples
Displaying Controller Information
Display the controller information for array with alias penquin.
armdsp -c penquin
Vendor ID:______________________________HP
Product ID:_____________________________A6218A
Array World Wide Name:__________________50060b00000970bc
Array Serial Number:____________________00USP1001080
Alias:__________________________________penquin
Software Revision:______________________1.08.00 - 0126 - 040630
Command execution timestamp:____________Jul 2, 2004 9:26:10 PM
------------------------------------------------------------
Controller At M/C1:
Status:_______________________________Good
Serial Number:________________________00PR00033597
-ps Displays the host and disk port metrics. Contact HP support for more
information on these metrics.
-s Display Array Status, Warnings and Subsystem Parameter information
for the array. This includes the configuration settings that control the
operation of the entire array. This command will also print the version of
Command View.
-t Display topology of back end ports. This display identifies the controller
paths to each disk in the array, the disk address, and the disk loop map.
For example, disk 1 in the controller (main) enclosure would be displayed
as follows:
M/D1 (M/C1.J1, M/C2.J1)*
See example below for more detail.
-vfp [<FruLocation>] Displays the VFP settings such as the Baud Rate and Paging Value.
If <FruLocation> is included and specifies either a controller (M/C1) or a
VFP port (M/C1.VFP), only the VFP information for that controller will be
displayed. If <FruLocation> is not included, VFP information for all VFP
ports within the enclosure will be displayed.
-? Display extended Usage message. This option overrides all other
switches.