HP StorageWorks Storage System Scripting Utility reference (September 2005)

ACCESSMODE=

Theaccessrightsforaconnectedhost.PossiblevaluesareREADONLY,PRESENTONLYandDISABLE.

ADD_VDISK=

Name of a source array virtual disk to be added to the DR Group. A destination virtual disk is

automatically created on the destination array.

NOTE:

Ifanameisalreadyinuse,thenamewillberejectedandyouwillbeaskedtoenteranewname.

When adding a virtual disk to the DR Group, the following two optional switches can be speciﬁed:

• DESTINATION_DISK_GROUP= The disk group name on the destination array on which the virtual

disk is created. This switch can be speciﬁed only after the ADD_VDISK switch.

• DESTINATION_VDISK_NAME= The name of the virtual disk that is created on the destination

array. The default name is the same as that of the source. This optional switch can be speciﬁed

only after the ADD_VDISK sw itch .

• TARGETREDUNDANCY= The redundancy level of the virtual disk that is cre ated on the destination

array.

COMMENT=

An optional ﬁeld for attaching comments to the D R Group being created. This string must be enclosed in

quotes. The maximum number of characters for this switch is 64.

DELETE_VDISK=

Name of a source a rray virtual disk to be removed from the DR Group. The corresponding destination

virtual disk on the destination array is removed from the DR Group and deleted from the array.

DETACH_VDISK=

Name of a source a rray virtual disk to be removed from the DR Group. The corresponding destination

virtual disk on the destination array is removed from the DR Group but not deleted. The detached

destination virtual disk continues to exist as an independent virtual disk.

FAILOVER_SUSPEND

The FAILOVER_SUSPEND command instructs the controller to perform the failover and after the failover is

done, suspend the connection between the DR groups.

FAILOVER RESUME

The FAILOVER_RESUME command instructs the controller to perform the failover and after the failover is

done, resu m e the connection between the DR groups.

FAILSAFE

When you use the FAILSAFE switch and the c onnection bet ween the source and the d estination array

fails, a ll writes are imm ediately halted and no write is reported as complete until either the connection is

restored or the NOFAILSAFE switch is set.

FORCEFULLCOPY

The FORCEFULLCOPY forces the DR Groups member to fully copy the source members to the destination

members and ignore the DR log.

HP StorageWorks Storage System Scripting Utilit y reference