4.1.0 HP Polyserve Software Installation Guide (T5392-96066, October 2010)

NOTE:
You can also add a single server using Add Server.
Export the configuration. Click Select All to select all of the servers in the Address
column. Then click Export To. The Last Operation Progress column will display status
messages as the configuration is exported to each server.
If you are using Web Management-based fencing, you may be asked for additional
information about each server. Based on the entries you made on the Fencing tab,
the information can include any or all of the following: the vendor/type for the Remote
Management Controller, the IP address/hostname of the Remote Management
Controller, the IBM Blade slot, the username and password for the Remote
Management Controller.
NOTE:
If you are using Web management-based fencing, you should now verify that the
remote management controller is configured correctly. See “Test the fencing
configuration” on page 39 for more information. Do not start Matrix Server until
you have completed the verification.
Start Matrix Server on the remaining servers. After exporting the configuration to the
remaining servers, click Select All to select all the servers in the Address column. Click
Start Service to start Matrix Server on those servers. As each server is started, a status
message will appear in the Last Operation Progress column. (If you are using Web
management-based fencing, also start Matrix Server on the first server.)
Install HP PolyServe Matrix Server38