4.1.0 HP Polyserve Software Installation Guide (T5392-96066, October 2010)

Select your storage type and, for Fibre Channel, specify the fencing method that you
want to use.
• Fibre Channel switch-based fencing, below.
• Web management-based fencing
Fibre Channel switch-based fencing
Complete the following on the SAN & Fencing tab:
SAN Switches. Specify the hostnames or IP addresses of the FibreChannel switches
that are directly connected to the nodes in the matrix. Click Add and then specify
the hostname or IP address of the first FC switch. Repeat this procedure to specify
the remaining FC switches, including cascading switches. If you are using an MPIO
configuration, be sure to configure all of the switches.
HP PolyServe Software 4.1.0 installation guide 27