4.1.0 HP PolyServe Software for Microsoft SQL Server administration guide (T5392-96074, October 2010)

Click Run to start the rehost operation. The tasks are checked off as they are
performed. When all tasks are completed successfully, the PolyServe Management
Console will show the new primary node for the Virtual SQL Server.
If a particular task fails, it is marked with an X on the progress report and you are
asked if you want to continue the operation. The progress report provides two options
that can be used if a task fails:
• Run. Click this button again to retry the failed task.
• Undo. Click this button to undo all tasks in the list and return the Virtual SQL
Server to its original state.
You can also cancel the operation at any time by clicking Cancel. HP PolyServe
Software will undo each of the completed steps and return the Virtual SQL Server to
its original state.
You can also use the following command to rehost a Virtual SQL Server:
mx vsql move [--force yes|no] [--policy autofailback|nofailback]
[--application <application_name> [––msdtc] <ip> <name>
([<networkinterface> ...])
The --force yes option causes the move to complete even if the operation
encounters an error. Be sure to specify the --msdtc option if MSDTC is currently
virtualized under the control of the Virtual SQL Server. If this option is omitted, MSDTC
will not be virtualized under the Virtual SQL Server.
HP PolyServe Software for Microsoft SQL Server 4.1 administration guide 89