4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

mx dynvolume – dynamic volume commands
Use the following commands to manage dynamic volumes.
DescriptionCommand
Convert a basic device to a dynamic volumeconvert
Create a dynamic volumecreate
Deport a dynamic volumedeport
Delete a dynamic volumedestroy
Dump dynamic volume configuration to stdoutdump
Extend a dynamic volumeextend
Import a dynamic volumeimport
Show all dynamic volumeslist
Display properties for a dynamic volumeproperties
List subdevices available for use in a dynamic volumeshowcreateopt
convert—Convert a basic device to a dynamic volume
mx dynvolume convert <filesystem>
create—Create a dynamic volume
mx dynvolume create [--reuse] [--stripesize <4KB-64MB>] <subDeviceName ...>
You can use either spaces or commas to separate the subdevice names. The --reuse
option causes the operation to proceed even though a specified partition may be
associated with an unimported dynamic volume. The operation will destroy the
dynamic volume previously using the partition. Be sure that you do not need the
unimported dynamic volume before doing this.
deport—Deport a dynamic volume
mx dynvolume deport <volumeName> ...
destroy—Delete a dynamic volume
mx dynvolume destroy <psv | volume GUID> ...
HP PolyServe Software 4.1 command reference guide 85