4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

Whether the device monitor can be active on only one server or on all of the
configured servers. With single, the monitor is active on only one of the selected
servers. Upon server failure, the monitor will fail over to an active server unless
all associated service and device monitors are down.
With always, the monitor is active on only one of the selected servers. Upon
server failure, the monitor will fail over to an active server even if all associated
service and device monitors are down.
With multiple, the monitor is active simultaneously on all selected servers.
[--vhosts <vhost1>,<vhost2>,...]
The virtual hosts associated with the device monitor. These virtual hosts will fail
over to another network interface when the monitored device fails. By default,
no virtual hosts are associated with the device monitor.
clear—Clear an error condition for a device monitor
mx device clear <devicename> <server> ...
delete—Delete a device monitor
mx device delete <devicename> ...
disable—Disable a device monitor on a server
mx device disable <devicename> <server> ...
dump—Dump device monitor configuration to stdout
mx device dump
enable—Enable a device monitor on a previously disabled server
mx device enable <devicename> <server> ...
status—Display the status of a device monitor
mx device status [arguments] [<devicename> ...]
The arguments are:
[--up|--down]
[--enabled|--disabled]
[--primary|--backup]
[--active|--inactive]
[--showApplication]
With no arguments, the command displays status for all device monitors.
update—Modify a device monitor
HP PolyServe Software 4.1 command reference guide 83