4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

parameter is the name of a file that the monitor probe should open and attempt
to read to determine the health of the filesystem. The filename should be rel-
ative to the mount point of the filesystem. When the filesystem is mounted,
the mount path will be prepended to the filename to determine the complete
filename path that should be probed. The second parameter is optional.
• NTSERVICE device monitor. Whether services dependent on the monitored
NT service should also be started when the NT service is started (specify
either Yes or No). If you want the services to be started, you can also specify
the number of attempts that should be made. Use a semicolon to separate
the values (for example, Yes;3).
[--ordering serial|parallel]
Whether Matrix Server enforces a strict ordering sequence when it runs Start or
Stop scripts. The default is serial, the strict ordering sequence.
[--recoveryScript <script>]
A script that runs after a monitor probe has failed. The script attempts to restore
the device. The script pathname can be up to 512 characters long.
[--recoveryTimeout <seconds>]
The amount of time to wait for the Recovery script to complete.
[--startScript <script>]
The Start script runs on the active server for a monitored device. The script
pathname can include up to 512 characters.
[--stopScript <script>]
A script that runs on all other servers configured for the monitor to ensure that
the device is not active on those servers. The script pathname can include up to
512 characters.
[--startTimeout <seconds>]
The amount of time to wait for the Start script to complete.
[--stopTimeout <seconds>]
The amount of time to wait for the Stop script to complete.
[--eventSeverity consider|ignore]
Whether Matrix Server takes device monitor events (such as a failure or timeout
of a Start or Stop script) into consideration when it makes failover decisions. The
default is consider.
[--probetype single|multiple]
Whether the monitor probe occurs on only one server or on all of the configured
servers.
[--activitytype single|always|multiple]
mx commands82