4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

DescriptionCommand
Dump the membership partition configurationdump
List the current membership partitions in a running or stopped
cluster
list
List disks that can be used for membership partitionslist_avail_disks
List partitions that can be used for membership partitionslist_avail_partitions
Repair a membership partitionrepair
Add or replace membership partitionsset
In general, these commands can be used when Matrix Server is online or offline.
However, when Matrix Server is running, the set and repair commands can be
used only under the following circumstances:
• A disk containing a membership partition is out-of-service (use the set command
to move the partition to another disk).
• You need to move one or more membership partitions to different storage (use
the set command to move the partitions one-at-a-time).
• In a cluster with three membership partitions, when Matrix Server started on a
server, it reported that a single membership partition was corrupt (use the repair
command to resilver the partition or use set to replace the partition).
• Your cluster contains a single membership partition and you want to add two
more partitions (use the set command).
• While the cluster is running, two membership partitions are reported to be corrupt
(use the repair command to resilver the partitions or use set to replace the
partitions).
When performing other operations with the set or repair commands, Matrix
Server must be offline on all servers in the cluster.
dump—Dump the membership partition configuration to stdout
mx config mp dump
list—List the current membership partitions
mx config mp list [--physical]
The --physical option returns the size of the LUNs containing the membership
partitions. Without this option, the output reports the size of the membership partitions
mx commands76