4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

from different vendors. This method must also be used for IBM BladeCenter
servers.
--hostsuffix <host suffix>
The common suffix to append to each server name to determine the associated
Remote Management Controller name. For example, if your server names are
server1 and server2 and their Remote Management Controllers are server1-iLO
and server2-iLO, specify -iLO as the suffix.
--ipdelta <ip delta>
The delta to add to each server’s IP address to determine the IP addresses of the
associated Remote Management Controllers. For example, if your servers are
1.255.200.12 and 1.255.200.15 and their Remote Management Controllers
are 1.255.201.112 and 1.255.201.115, specify 0.0.1.100 as the delta.
--mixedvendor yes|no
Whether the vendor and type settings apply to all servers.
[--rpassword <password>]
The password for the Remote Management Controller.
--ruser <user name>
The user name for the Remote Management Controller.
[--sharedlogin yes|no]
Whether the login is shared by all servers.
--type reset|shutdown
When a server needs to be restricted from the SAN, Matrix Server can either
power-cycle the server or shut it down. Select the method that you want to use
(either reset or shutdown).
--vendor <vendor>
The vendor for your remote management controller (dell, hp, ibm, or ipmi).
mx config mp – membership partition commands
Use the following commands to manage membership partitions on an online or offline
cluster.
NOTE:
If you are performing the initial configuration of a cluster, the mx config, mx
config mp, and mp config snapshot commands must be entered in a specific
order. See the HP PolyServe Matrix Server installation guide for more information.
HP PolyServe Software 4.1 command reference guide 75