4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

DescriptionCommand
Get the cluster configurationlist
Set the administrative traffic protocolprotocol
Test the switch configurationsantest
Set the SAN storage typesantype
Set the cluster secret license keysecret
Test the fencing configurationtestfencing
Configure the web-based fencing modulewebfencing
check—Check the cluster configuration
mx config check
This command specifies whether cluster components are configured or unconfigured.
It does not verify that components are configured correctly. To see the state of each
component, use commands such as mx config list and mx config mp list.
This command can be used when the cluster is either online or offline.
description—Set the cluster description
mx config description <description>
The description can contain up to 80 characters. This command can be used only
during the initial configuration of the cluster or when the cluster is online.
dump—Dump the cluster configuration
mx config dump
This command can be used when the cluster is either online or offline.
export—Export the cluster configuration
mx config export <server> ...
This command can be used when the cluster is either online or offline.
fcfencing—Set FibreChannel as the fencing method
mx config fcfencing
This command can be used only when the cluster is offline.
fcswitch—Configure a FibreChannel switch into the cluster
HP PolyServe Software 4.1 command reference guide 71