4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

disable—Disable an application
mx application disable <application_name> <server>
enable—Enable an application
mx application enable <application_name> <server>
rename—Rename an application
mx application rename <current_name> <new_name>
status—Show status for an application
mx application status [--severity OK|WARNING|ERROR] [<application> ...]
mx config – cluster configuration commands
Use the following commands to configure the cluster.
NOTE:
If you are performing the initial configuration of a cluster, the mx config, mx
config mp, and mx config snapshot commands must be entered in a specific
order. See Appendix A in the HP PolyServe Matrix Server installation guide for more
information.
DescriptionCommand
Check the cluster configurationcheck
Set the cluster descriptiondescription
Dump the cluster configurationdump
Export the cluster configurationexport
Select FibreChannel as the fencing methodfcfencing
Configure a FibreChannel switch into the clusterfcswitch
Import the cluster configurationimport
Install the cluster licenselicense
mx commands70