4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

# mxsanlk
This host: 99.10.30.3
This host’s SDMP administrator: 99.10.30.1
Membership Partition SANlock State
-------------------- -------------
psd1p1 held by SDMP administrator
psd2p1 held by SDMP administrator
psd3p3 held by SDMP administrator
Any of these messages can appear in the “SANlock State” column.
held by SDMP administrator
The SANlock was most recently held by the SDMP administrator of the cluster to
which the host where mxsanlk was run belongs.
trying to lock, last held by host X.X.X.X
The SANlock was most recently held by host X.X.X.X and may still be held by
that host. The host on which mxsanlk was run is trying to acquire the SANlock.
cannot access
The host on which mxsanlk was run is unable to access the SANlock. The
membership partition may need to be repaired.
trying to lock, not yet committed by owner
The SANlock is either not held or has not yet been committed by its holder. The
host on which mxsanlk was run is trying to acquire the SANlock.
unlocked, trying to lock
The SANlock does not appear to be held. The host on which mxsanlk was run
is trying to acquire the SANlock.
unlocked
The SANlock does not appear to be held. If a host holds the SANlock, it has not
yet committed its hold.
initiating sdmp, not yet examined
This is a transitional state. It indicates that the SDMP process responsible for the
SANlock has been started but has not yet accessed the SANlock.
sdmp process hung
The SDMP process responsible for the SANlock is unresponsive.
trying to lock, sdmp process hung
The host on which mxsanlk was run is trying to acquire the SANlock but the
SDMP process responsible for the SANlock is unresponsive.
locked, sdmp process hung
Cluster commands34