4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

recreates the membership partitions from scratch based on the contents of the
input file.
mpimport -r <psdname>|<psvname> [<psdname>|<psvname> ...]
Remove the specified disks or dynamic volumes from the existing database.
mpimport --replace <olduid> <newuid>
Replace all occurrences of olduid with newuid throughout the membership
partition data.
mpimport -X
Restore the mxds datastore on the membership partitions using the default backup
file (MPmxds.backup).
mpimport -x <backup-file>
Restore the mxds datastore on the membership partitions using the specified
backup file.
mprepair.exe – repair membership partitions
Synopsis
bin\mprepair
Description
The mprepair utility can be used to repair any problems if a failure causes servers
to have inconsistent views of the membership partitions. This utility is invoked from
the operating system prompt.
NOTE:
Matrix Server cannot be running when you use mprepair. To stop the matrix, issue
the command net stop matrixserver from the Command Prompt.
View membership partitions and their status
To view the current membership partitions, type the following command at the
operating system prompt:
mprepair --get_current_mps
This command lists the current membership partitions according to the membership
file maintained on the server where you are running the utility. Each server in the
HP PolyServe Software 4.1 command reference guide 25