4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

--activitytype single|always
Whether, upon server failure, the virtual host will move to an active server if all
associated service and device monitors are inactive or down. If always is spe-
cified, the failover will occur. If single is specified, the failover will not occur
and the virtual host will not be made active anywhere. single is the default.
<vhost> can be either the hostname or the IP address for the virtual host. If you
specify the hostname, it can include up to 32 characters.
The order in which you specify the network interfaces determines the ordering
for failover. The first network interface is the primary interface; network traffic
for the virtual host goes to the server providing this interface. The remaining
network interfaces are backups. Each network interface must be located on a
different server.
delete—Delete a virtual host
mx vhost disable <vhost>
disable—Disable a virtual host
mx vhost disable <vhost>
dump—Dump the virtual host configuration to stdout
mx vhost dump
enable—Enable a virtual host
mx vhost enable <vhost>
move—Move a virtual host to another server
mx vhost move [--policy autofailback|nofailback] [--application
<application_name>] [--activitytype single|always] <vhost>
([<network_interface> ...] [ALL_SERVERS <network_interface>])
The options are the same as mx vhost add.
status—Display the status of a virtual hosts
mx vhost status [arguments] [<vhost> ...]
The arguments are:
[--primary|--backup]
[--active|--inactive]
[--up|--down]
[--enabled|--disabled]
[--showApplication]
mx commands128