4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

The maximum amount of time to wait for a probe of the device to complete. For
NTSERVICE monitors, the default is 15 seconds. For CUSTOM service monitors,
the default is 60 seconds. For all other service monitors, the default is five seconds.
[--frequency <seconds>]
The interval of time at which the monitor probes the service. For CUSTOM service
monitors, the default is 60 seconds. For all other service monitors, the default is
30 seconds.
[--probetype single|multiple]
This argument applies only to CUSTOM monitors.
[--probeSeverity nofailover|autorecover|noautorecover]
The failover behavior for the service monitor. nofailover prevents failover of
the virtual host when the monitored service fails. autorecover fails over the
virtual host and, when the service is restored, fails the virtual host back to the
original network interface. noautorecover fails over the virtual host but does
not fail it back after the service is restored. autorecover is the default. These
settings work in combination with the virtual host’s failback policy.
Note that this command is case-sensitive.
[--parameters <parameters>]
The parameters are as follows:
• HTTP or HTTPS monitor. The parameter is the URL for the service.
• DNS monitor. The parameter is the address to be resolved.
• NTSERVICE monitor. The parameter specifies whether services dependent on
the monitored NT service should also be started when the NT service is started
(specify either Yes or No). If you want the services to be started, you can also
specify the number of attempts that should be made. Use a semicolon to
separate the values (for example, Yes;3)
• CUSTOM monitor. The parameter is a probe script.
[--ordering serial|parallel]
Whether Matrix Server enforces a strict ordering sequence when it runs Start or
Stop scripts. The default is serial, the strict ordering sequence.
[--recoveryScript <script>]
Runs after a monitor probe failure is detected, in an attempt to restore the service.
[--recoveryTimeout <seconds>]
The amount of time to wait for the script to complete.
[--startScript <script>]
When Matrix Server selects the active server for a monitored service, the Start
script runs on that server.
HP PolyServe Software 4.1 command reference guide 117