4.1.0 HP PolyServe Software command reference guide (T5392-96071, October 2010)

[--timestamp <startTime,endTime>]
Filter by a particular time range expressed as <startTime,endTime>.
[--noHeaders]
Do not display column headers in the output.
[--csv]
Display the output in comma-separated value format.
[--showborder]
Display borders in the output.
mx service – service monitor commands
Use the following commands to configure service monitors or to display their status.
DescriptionCommand
Create a service monitoradd
Clear a service monitor errorclear
Remove a service monitordelete
Disable a service monitordisable
Dump the service monitor configurationdump
Enable a service monitorenable
Show the status of service monitorsstatus
Modify the configuration of a service monitorupdate
add—Create a service monitor
mx service add --type <type> [arguments] <vhost:port> ...
The arguments are:
--type <type>
The type of service monitor (DNS, FTP, HTTP, HTTPS, IMAP4, NNTP, NTSERVICE,
POP3, SMTP, TCP, CUSTOM).
[--timeout <seconds>]
mx commands116