4.1.0 HP Polyserve Matrix Server Upgrade Guide (T5392-96067, October 2010)

19. On the Matrix Wide Configuration tab, start Matrix Server on all of the servers
in group A. The servers in group A are now operational.
IMPORTANT:
Be sure to review the drive letter and mount point assignments on each
server and restore any missing or incorrect assignments.
20. If you are using HP PolyServe Software for Microsoft SQL Server, install the SQL
instance on the newly upgraded server. On the PolyServe Management Console,
select Tools > Install SQL. Select only the newly upgraded node for installation.
(For more information about installing SQL instances, see the HP PolyServe
Software for Microsoft SQL Server administration guide.)
21. Apply SQL Server service pack/hot fixes on the upgraded servers. On the
PolyServe Management Console, select Tools > SP/Hotfix Update SQL. Select
only the newly upgraded servers for installation.
22. Reboot the upgraded servers.
23. Enable hosting on the upgraded servers. On the Management Console, open
the Virtual Hosts tab and select the virtual host (such as a Virtual SQL Server or
Virtual CIFS Server) that was primary on that server. Right-click and select Rehost.
On the Rehost dialog, select the network interface for the upgraded server and
click OK.
24. On the Matrix Wide Configuration tab, stop Matrix Server on each server in
group B.
25. Back up the matrix configuration on each server in group B as described under
“Back up the existing matrix” on page 5.
26. Shut down the servers in group B.
27. Reinstall the operating system on each server in group B.
28. If you will be adding third-party MPIO software to the matrix, install it on each
server in group B according to the product documentation.
29. On each server in group B, install a supported HBA driver.
30. Reboot the servers in group B.
31. On each server in group B, install Matrix Server 4.1.0. Locate the file
MxS_4.1.0<xxxx>.msi on the product CD or in the directory where you
downloaded the software. Right-click the MxS_4.1.0.<xxxx>.msi file and
select Run as Administrator to start the Installation Wizard. To complete the
installation, reboot the servers when directed by the popup message.
Non-rolling upgrades18