4.1.0 HP Polyserve Matrix Server Upgrade Guide (T5392-96067, October 2010)

15. Open the Configure Matrix window. On the console for the server being
upgraded, select Start > Programs > PolyServe Matrix Server > PolyServe
Configuration Utility. Answer no if you are asked whether you want to start the
matrix on the server and then select the configure option. If you are asked for
login credentials, enter the credentials for the server that you are upgrading.
Then click the down arrow on the Connect button to see the options and select
Configure.
16. Install the new license file. On the General Settings window, select Change
License File and install the new license.
17. Click Apply on the bottom of the Matrix Configuration window. (You may be
prompted to reenter the Administrative password. You can click Apply again if
necessary to redisplay the password prompt.) Answer No when you are asked
whether you want to start the matrix.
NOTE:
If the Apply fails, verify that the FC switch ports are enabled for all of the
servers. If the switch ports are enabled, check the Windows Disk
Management MMC snap-in to determine whether the node can see the
disks on the SAN and whether the disks are online. Also check the HBA
driver.
18. Go to the Matrix Wide Configuration tab and export the updated configuration
to all other servers in group A. (You may be asked for the password on each
server.)
NOTE:
If the export fails, verify that the FC switch ports are enabled for all of the
servers. If the switch ports are enabled, check the Windows Disk
Management MMC snap-in to determine whether the node can see the
disks on the SAN. Also check the HBA driver.
HP PolyServe Software 4.1.0 upgrade guide 17