4.1.0 HP PolyServe Matrix Server administration guide (T5392-96073, October 2010)

The window also lists the UIDs and sizes of the LUNs (both imported and unimported)
that are available for filesystems.
Display disk information with sandiskinfo
The sandiskinfo command can display information for both imported and
unimported SAN disks (or LUNs) and also for dynamic volumes. Under normal
operations, the sandiskinfo output should be the same on all servers in the cluster.
NOTE:
Matrix Server should be running when the sandiskinfo command is used on the
cluster node. To start the matrix server service on the node, issue the command net
start matrixserver from the command prompt.
Disk information
With no options, sandiskinfo displays the UID, vendor, model, and capacity of
each imported disk and specifies the FC switch used to access the disk.
# sandiskinfo
Disk: \\.\Global\psd2
Uid: 20:00:00:04:cf:13:38:3a::0 SAN info: fcswitch5:7
Vendor: SEAGATE Capacity: 34733M
Following are commonly used options for imported and unimported disks:
sandiskinfo [-i|-u|-v|-f] [-alr] [-U] [-q]
The options are:
-I Display information for imported disks (the default).
-u Display information for unimported disks.
-v Display available volumes.
-f Display PSFS filesystem volumes.
-a Display all information; for -v, display all known volumes.
-l Additionally display host-local device name.
-r Additionally display local device route information.
HP PolyServe Matrix Server 4.1.0 administration guide 79