4.1.0 HP PolyServe Matrix Server administration guide (T5392-96073, October 2010)

a Host Bus Adapter or driver on a server. All commands are run from the Command
Prompt.
1. Stop Matrix Server:
net stop matrixserver
2. Disable the Matrix Server service:
mxservice -uninstall
3. Remove the psd driver from the driver stack:
psdcoinst -uninstall
4. Reboot the server. The server will come up without Matrix Server and the psd
driver.
5. Make the necessary change to the HBA or driver. Reboot the system if the HBA
installation prompts you to do so.
6. (Optional.) Verify that the new HBA is supported:
mxcheck
7. Update the registry:
regedit /s psd.reg
8. Enable Matrix Server and the psd driver:
mxservice -install
psdcoinst -install
9. Reboot the server to return the psd driver to the driver stack.
10. When the system is rebooted, Matrix Server will still be disabled in the Windows
Services Control Panel. Re-enable it for Automatic startup if desired.
11. Start Matrix Server (or wait until the next reboot).
net start matrixserver
Servers
Change the fencing method
To change the fencing method, complete these steps:
1. Stop Matrix Server on all servers in the cluster.
SAN maintenance256