4.1.0 HP PolyServe Matrix Server administration guide (T5392-96073, October 2010)

successful, the monitor sends the string QUIT\n to the server. If there are no errors,
the service status remains Up. If an error occurs, the status is set to Down.
To create a FTP site that can be hosted on a Matrix Server virtual host, use the
following configuration. On the Internet Information Services (IIS) 6.0 Manager (click
Start > All Programs > Administrative tools), right click the FTP site and select
Properties. On the FTP Site Properties window, select the FTP site tab and ensure that
the IP address is configured to (All Unassigned).
HTTP service monitor
By default, the HTTP service monitor probes TCP port 80 of the virtual host address.
You can change this port number to the port number configured for your HTTP server.
The default frequency for the probe is every 30 seconds; the default time that the
service monitor waits for a probe to complete is five seconds.
You can also supply a URL (either a directory or a full URL) that will be read as part
of the probe function. The probe attempts to connect to the HTTP server and read the
URL. If the response from the HTTP server is a success code (200 <= reply < 300),
then the service status remains Up. If the probe does not receive a success code or
it takes more than five seconds to get the reply from the HTTP server, the service status
is set to Down. (You can view the reply code from the PolyServe Management
Console; select the service monitor, right-click, and select View Last Error.)
To create a web site that can be hosted on a Matrix Server virtual host, use the
following configuration. On the Internet Information Services (IIS) Manager (click
Start > All Programs > Administrative tools), right click the Web site and select Edit
Bindings. On the Edit Bindings window, ensure that the IP address is configured to
(All Unassigned).
HTTPS service monitor
This monitor functions in the same manner as the HTTP service monitor; however, it
uses the HTTPS protocol to make the connection to port 443. The URL specified for
the monitor should begin with HTTPS.
NT service monitor
The NTSERVICE service monitor is configured for a specific NT service. When the
service monitor instance becomes active, it will start the NT service if it is not already
started. When the service monitor instance becomes inactive, the monitor stops the
NT service if the probe type for the monitor is set to Single-Probe. When you configure
HP PolyServe Matrix Server 4.1.0 administration guide 205