4.0.0 HP Polyserve Matrix Server Installation Guide (T5392-96046, March 2010)

SAN Switches. Specify the hostnames or IP addresses of the FibreChannel switches
that are directly connected to the nodes in the matrix. Click Add, and then specify
the hostname or IP address of the first FC switch.
Repeat this procedure to specify the remaining FC switches, including cascading
switches.
SNMP Community String. The default SNMP community string for Matrix Server is
private. If you want to use a custom community string, enter the appropriate value
here. The SNMP community string must be set to the same value on Matrix Server
and on the SAN switches configured above.
When the SAN & Fencing tab is complete, go to the Storage Settings tab.
Storage Settings tab
The Storage Settings tab allows you to select membership partitions, which Matrix
Server uses to control access to the SAN, and to create a snapshot configuration for
taking hardware snapshots.
Install PolyServe Matrix Server32