4.0.0 HP Polyserve Matrix Server Event Notification Guide (T5392-96053, March 2010)

Message and Corrective ActionID
Inaccessible membership partition resolved.
Action. None. Alert 13909 is resolved.
13910
DiskImportError: <server> unable to access imported disk <disk_id>/psd<n>.
When the matrix configuration was imported to the server, it was not able to access
the specified disk. The filesystems on the disk were not mounted on the server.
Action. To correct this problem, first verify that the server has physical access to
the disk in question and that the disk is not experiencing hardware problems. Then
attempt a reboot. If the same error occurs after one reboot, contact HP Support.
13911
<server> unable to access imported disk <disk> resolved.
Action. None. Alert 13911 is resolved.
13912
Membership partition <partition> should be least <size>.
Action. The minimum size for a membership partition is 1GB. The specified partition
is too small and should be replaced. If three membership partitions are configured,
you can replace the partition while the matrix is online. (Use the Replace feature
on the Storage Settings tab of the Configure Matrix window.) If only one
membership partition is configured, add two more partitions using the Add feature
on the Storage Settings tab and then replace the original partition.
13913
Membership partition size resolved.
Action. None. Alert 13913 is resolved.
13914
Membership partition <partition> corrupt and must be repaired as soon as
possible.
Action. Use the mx config mp repair command or the Repair button on the
Storage Settings tab of the Configure Matrix Window to repair the partition while
the matrix is online. If the matrix is offline, use the mx config mp repair command
or resilver the partition with the mxmpconf utility.
13915
Membership Partition <partition> corruption resolved.
Action. None. Alert 13915 is resolved.
13916
Event messages32