4.0.0 HP Polyserve Matrix Server Command Reference Guide (T5392-96048, March 2010)

enable—Enable a Virtual CIFS Server
mx vfs enable <ip>|<name>
move—Rehost a Virtual CIFS Server to the specified interface
mx vfs move <ip>|<name> <target network interface>])
The target network interface must be currently configured for the Virtual CIFS Server.
status—Display the status of a Virtual CIFS Servers
mx vfs status [arguments] [<vhost> ...]
The arguments are:
[--primary|--backup]
[--active|--inactive]
[--up|--down]
[--enabled|--disabled]
[--showApplication]
With no arguments, the command displays the status of all virtual hosts.
update—Modify an existing Virtual CIFS Server
mx vfs update [--policy autofailback|nofailback] [--application
<application>] <ip> <name> ALL_SERVERS
<primary network_interface> <network_interface> ...
This command allows you to add or remove interfaces from the Virtual CIFS Server
configuration and to reorder the interfaces. If you specify a different primary interface
and --policy is set to autofailback, the command will automatically move the
service to the new primary.
If --policy is set to nofailback, the update command will not move the service to
the new primary. You will then need to use the vfs move command to move the
service.
mx vfs_share – Virtual File Share commands
Use the following commands to configure a Virtual File Share or to display its status.
DescriptionCommand
Add a Virtual File Shareadd
Remove a Virtual File Sharedelete
PolyServe Software command reference guide 123