4.0.0 HP Polyserve Matrix Server Administration Guide (T5392-96052, March 2010)

When you select a partition and click Replace, you will see a confirmation message
describing the replace operation. A message also appears when the replace operation
is complete.
NOTE:
The Replace option on the Storage Settings tab is available only when Matrix Server
is running.
Add membership partitions
When you initially configure the matrix, you can add either one or three membership
partitions, as described in the HP PolyServe Matrix Server installation guide. If only
one partition is configured, you can add two partitions when Matrix Server is either
online or offline. Click Add on the Storage Settings tab to create the partitions. The
Add Membership Partition window then lists all of the disks or LUNs that it can access.
Select a disk or LUN for the first membership partition you are adding.
All of the available partitions on that disk or LUN then appear in the bottom of the
window. Select one of these partitions and click Add. (The minimum size for a
membership partition is 1 GB.) Repeat this procedure to select one more membership
partition. HP recommends that the partitions be on different disks.
When selecting partitions for use as membership partitions, be sure that they do not
contain any needed data. When the membership partitions are created, any existing
data will be erased.
SAN maintenance248