4.0.0 HP Polyserve Matrix Server Administration Guide (T5392-96052, March 2010)

• CID_MISMATCH. The Cluster-ID is out-of-sync among the membership partitions
and must be reset.
Repair a membership partition
When Matrix Server is started on a server, it checks the status of the membership
partitions and reports any invalid partitions. If a single membership partition is found
to be corrupt, you can repair that partition while Matrix Server is running. (If more
than one partition is corrupt, Matrix Server must be offline when the partitions are
repaired.)
The repair operation resilvers the membership partition. Highlight the bad partition
on the Storage Settings tab and click Repair. The operation then takes place.
Replace a membership partition
The replace operation replaces an existing membership partition with a new partition.
This operation can be used if a disk containing a membership partition is out of
service or if you need to move membership partitions to new storage. You can also
use this operation to replace a corrupt membership partition.
The replace operation can be performed online only if there are currently three
membership partitions. Only one partition can be replaced at a time. Highlight the
partition to be replaced on the Storage Settings tab and click Replace. The Select
Replacement Membership Partition window lists the disks or LUNs that are available.
Click a disk or LUN to see the partitions on the disk or LUN.
HP PolyServe Matrix Server administration guide 247