3.7.0 HP StorageWorks HP Scalable NAS File Serving Software event notification guide HP Scalable NAS for Linux (AG513-96007, June 2009)

Message and Corrective ActionID
Server <server> fencing failure resolved.
Action. None. Alert 13907 is resolved.
13908
Membership partitions are corrupt or inaccessible, preventing SAN access.
Action. Determine the state of each membership partition. Open the Configure
Cluster window and go to the Storage Settings tab, which shows the state of each
partition. If a single membership partition is corrupt, use the Repair feature to
resilver the partition while the cluster is online. If two partitions are corrupt, shut
down the cluster on all nodes and then resilver the partitions. If all of the
membership partitions are corrupt, you will need to restore the partitions from a
backup. If the state for a partition is NOT FOUND or INACCESSIBLE, there may
be a problem with the disk containing the partition or with another SAN component.
When the problem is repaired, the status should return to OK.
13909
Inaccessible membership partition resolved.
Action. None. Alert 13909 is resolved.
13910
DiskImportError: <server> unable to access imported disk <disk_id>/psd<n>.
When the cluster configuration was imported to the server, it was not able to
access the specified disk. The filesystems on the disk were not mounted on the
server.
Action. To correct this problem, first verify that the server has physical access to
the disk in question and that the disk is not experiencing hardware problems. Then
attempt a reboot. If the same error occurs after one reboot, contact HP Support.
13911
<server> unable to access imported disk <disk> resolved.
Action. None. Alert 13911 is resolved.
13912
Membership partition <partition> should be least <size>.
Action. The minimum size for a membership partition is 1GB. The specified partition
is too small and should be replaced. If three membership partitions are configured,
you can replace the partition while the cluster is online. (Use the Replace feature
on the Storage Settings tab of the Configure Cluster window.) If only one
membership partition is configured, add two more partitions using the Add feature
on the Storage Settings tab and then replace the original partition.
13913
Membership partition size resolved.
Action. None. Alert 13913 is resolved.
13914
HP Scalable NAS File Serving Software event notification guide 31