3.7.0 HP StorageWorks HP Scalable NAS File Serving Software command reference guide HP Scalable NAS for Linux (AG513-96003, October 2009)

The maximum amount of time to wait for a probe of the device to complete. For
DISK and SHARED_FILESYSTEM device monitors, the default is five seconds. For
CUSTOM device monitors, the default is 60 seconds.
[--frequency <seconds>]
The interval at which the monitor probes the device. For DISK and
SHARED_FILESYSTEM device monitors, the default is 30 seconds. For CUSTOM
device monitors, the default is 60 seconds.
[--probeSeverity nofailover|autorecover|noautorecover]
The failover behavior for the monitor. With nofailover, when the monitor
probe fails, the virtual host does not fail over.
With autorecover, the virtual host fails over when a monitor probe fails. When
device access is recovered on the original node, failback occurs according to
the virtual host’s failback policy. This is the default.
With noautorecover, the virtual host fails over when a monitor probe fails
and the monitor is disabled on the original node, preventing automatic failback.
When the monitor is reenabled, failback occurs according to the virtual host’s
failback policy.
[--parameters <parameters>]
The available parameters depend on the type of monitor.
• DISK device monitor. The parameter is a partition on the disk. The monitor
will attempt to read the first block on this partition to determine whether the
disk is operating normally.
• CUSTOM device monitor. The parameter is a probe script. The maximum
length of the pathname is 512 characters.
• SHARED_FILESYSTEM device monitor. The first parameter is the device (for
example, psd1p6) containing the filesystem to be monitored. The second
parameter is the name of a file that the monitor probe should open and attempt
to read to determine the health of the filesystem. The filename should be rel-
ative to the mount point of the filesystem. When the filesystem is mounted,
the mount path will be prepended to the filename to determine the complete
filename path that should be probed. The second parameter is optional.
[--ordering serial|parallel]
Whether HP Scalable NAS enforces a strict ordering sequence when it runs Start
or Stop scripts. The default is serial, the strict ordering sequence.
[--recoveryScript <script>]
A script that runs after a monitor probe has failed. The script attempts to restore
the device. The script pathname can include up to 512 characters.
[--recoveryTimeout <seconds>]
mx commands108