3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, October 2009)

node. For more information about this feature, see Virtualized NFSD RPC reply
caches, page 197.
NLM locking protocol
The NLM locking protocol is enabled by default. For more information about this
protocol, see Using the NLM protocol, page 195
NOTE:
If Oracle over NFS is used, be sure to use the default setting for the NLM locking
protocol. This setting is valid for Oracle when accessing filesystems from within the
cluster or over NFS.
Stand-alone version of HP Scalable NAS
Management Console
The HP Scalable Management Console is available in stand-alone versions that can
be installed on Linux or Windows systems outside the cluster.
The Windows version of the stand-alone is provided at the following location on the
cluster servers:
/opt/hpcfsmgmt/tools/mxconsole-3.7.0-<xxxx>.x86.msi
The Linux version of the console is provided at the following location on the cluster
servers:
/opt/hpcfsmgmt/tools/mxconsole-3.7.0-<xxxx>.<arch>.rpm
System requirements for the stand-alone console
Systems used for the Windows versions of the stand-alone HP Scalable NAS
Management Console must meet the following requirements:
• Pentium-compatible processor or later
• 32 or 64 MB of memory
• Windows 2000, Windows XP, or Windows 2003
Systems used for the Linux version of the stand-alone HP Scalable NAS Management
Console must meet the following requirements:
HP Scalable NAS File Serving Software administration guide 423