3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, October 2009)

All of the available partitions on that disk or LUN then appear in the bottom of the
window. Select one of these partitions and click Add. (The minimum size for a
membership partition is 1 GB.) Repeat this procedure to select one more membership
partition. HP recommends that the partitions be on different disks.
When selecting partitions for use as membership partitions, be sure that they do not
contain any needed data. When the membership partitions are created, any existing
data will be erased.
When you have completed your selections, click Apply at the bottom of the Configure
Cluster window.
Remove membership partitions
Before using this option, verify that HP Scalable NAS is offline on all nodes in the
cluster. When you click Remove, a dialog listing the current membership partitions
is displayed. Select the partition that you want to delete. When you have completed
the dialog, click Apply at the bottom of the Configure Cluster window.
The mx config mp commands
The mx config mp set and repair commands can be used while HP Scalable
NAS is either online or offline; however, only the operations listed under Online
operations, page 359 can be performed while HP Scalable NAS is running. For other
operations, HP Scalable NAS must be offline on all nodes in the cluster.
HP Scalable NAS File Serving Software administration guide 363