3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, October 2009)

your server. Set domain to the NIS domain that should be monitored by the NIS
probe. The rpcinfo command can be useful for determining the correct values
for proto, rpcname, and rpcvers.
• Custom service monitor. You will be asked for the location of the user probe script.
Enter the pathname for the probe script to be used with the monitor. See Custom
scripts, page 345 for information about writing probe scripts.
When you complete the Add Service Monitor form, the new monitor appears on the
Management Console, as shown in the following example.
To add or update a service monitor from the command line, use this command:
mx service add|update [--type <type>] [--timeout <seconds>]
[--frequency <seconds>] [<other_arguments>] <vhost:port> ...
NOTE:
The --type argument cannot be used with mx service update.
See “Advanced Settings for Service Monitors,” below, for information about the other
arguments that can be specified for service monitors.
Advanced settings for service monitors
You can use the advanced settings to fine-tune service monitors. To access the
advanced settings, click Advanced on the Add Service Monitor or Service Monitor
Properties window.
Service monitor policy
The Policy tab lets you specify the failover behavior of the service monitor and set its
service priority.
Configure service monitors320