3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, October 2009)

Debug log
Replication errors and warning messages are logged in /var/opt/hpcfs/debug/
rpl.log and also appear in the HP Scalable NAS event viewer on the Management
Console.
Repair damaged or deleted ssh keys
The current key pair is stored in the mxds datastore. If the key pair installed on the
source or destination cluster becomes damaged or is deleted, run the following
command to reinstall the key pair from the mxds datastore.
# rplkeys
Use rplkeys -D to reset the keys to the shipped defaults.
Fix connection errors
If connection errors are reported when replication attempts to access the destination
cluster, take these steps:
• Check the IP address specified for the destination cluster in the configuration file.
Run the command rplconfig -e <config_file> to export the configuration
file from the mxds datastore. If necessary, correct the file and reimport it back to
the mxds datastore.
• On a node in the destination cluster, run the rplkeys script to ensure that the
replication key pair is installed.
Resend a transmission after a replication failure
If a replication failure is reported for a particular node, replication changes may
have been lost. Run the following command to recursively transport the affected
directory to the destination cluster.
# rplwatch -c <directory_name>
The directory name must be either a directory specified in the configuration file or a
subdirectory of a directory listed in the file.
Configure and manage replication272