3.7.0 HP StorageWorks HP Scalable NAS File Serving Software administration guide - HP Scalable NAS 3.7 for Linux (AG513-96002, October 2009)

FS Option with a custom application where certain application-specific actions must
be taken before failback can occur.
To set the Probe Severity from the command line, use this option:
--probeSeverity nofailover|autorecover|noautorecover
Scripts
The Scripts tab lets you configure custom Recovery, Start, and Stop scripts for the
Export Group monitor.
Monitors can optionally be configured with scripts that are run at various points
during cluster operation. The script types are as follows:
Recovery script. Runs after a monitor probe failure is detected, in an attempt to restore
the NFS service.
Start script. Runs as the NFS service is becoming active on a server.
Stop script. Runs as the NFS service is becoming inactive on a server.
When a monitor is instantiated, HP Scalable NAS selects the best node to make the
service active. The Start script is run on this node. The Stop script is run on all other
HP Scalable NAS File Serving Software administration guide 179