3.6.1 HP PolyServe Matrix Server Event Notification Guide (T5392-96028, August 2008)

Chapter 3: Event Messages 34
13929 Membership Partition <partition> does not belong to this cluster; cannot use.
Action. Determine whether the specified membership partition belongs to
this matrix. Use the Storage Settings tab on the Configure Matrix window or
the mpdump command to see the membership partitions configured for the
matrix. If the partition does belong to the matrix, first verify that no other
matrix is using it. Then stop Matrix Server on all nodes and run the
command mprepair --sync-clusterids. See the PolyServe Matrix Server
Administration Guide for more information about this command.
13930 Cluster now owns Membership Partition <partition>; problem resolved.
Action. None. Alert 13929 is resolved.
13933 FenceAgent <IP_address>: no response to queries from <server>.
Fabric fencing is configured and a node has lost network access or the
FibreChannel switch is unresponsive.
Action. Possible causes of the error are:
• The server has experienced a total loss of network access to the
FibreChannel switch(es).
• A FibreChannel switch has become unresponsive to snmp requests.
• The dependent r/w community string has been changed or deleted.
For the Cisco MDS FibreChannel switch with firmware version 2.1 or later,
the default VSAN (VSAN 1) is likely disabled, which causes
fcFeFabricName (FA-MIB defined) to be unassigned (all zeros). Currently
Matrix Server uses the OID assignment for fcFeFabricName to probe
connected FC switches and will return the above error messages if it is
unable to determine a value for fcFeFabricName. The messages can be
quiesced by enabling the default VSAN (VSAN 1).
The following utility specifies whether a server can communicate with the
FibreChannel switch. The command displays the name service entries of the
WWPN and the Fabric IDs of the switch. It may take approximately five or
six seconds for the output to be displayed.
PSANinfo -c <snmp community string> <IP address of FC
switch>
13934 FenceAgent <IP_address>: no response to queries from <server> resolved.
Action. None. Alert 13933 is resolved.
ID Message and Corrective Action