3.6.1 HP PolyServe Matrix Server Administration Guide (T5392-96018, August 2008)

Chapter 8: Configure Dynamic Volumes 82
To create a dynamic volume from the command line, use this command.
You can use either spaces or commas to separate the subdevice names.
mx dynvolume create [--stripesize <4KB-64MB>] <subDeviceName ...>
The following command lists the available subdevices:
mx dynvolume showcreateopt
Dynamic Volume Properties
To see the configuration for a dynamic volume, select Storage > Dynamic
Volume > Volume Properties and then choose the volume that you want
to view. If a filesystem is associated with the volume, the Volume
Properties window shows information for both the dynamic volume and
the filesystem.
The Stripe State reported in the “Dynamic Volume Properties” section
will be one of the following:
• Unstriped. The volume is concatenated and striping is not in effect.