3.6.1 HP PolyServe Matrix Server Administration Guide (T5392-96018, August 2008)

Chapter 4: Matrix Administration 38
Use the following command at the Command Prompt to see the software
installed on specific servers:
mx server listsoftware <server>
If the operating system uses the 64-bit architecture, x64 will be specified
in the output. Otherwise, the architecture is assumed to be 32-bit.
Start or Stop Matrix Server
By default, Matrix Server (the matrixserver service) starts automatically
when the system is booted. This feature is controlled by the Startup
dialog. If you do not want Matrix Server to start when the system is
booted, use one of these methods to disable the service:
• Open the Startup dialog and change the service from Automatic to
Disabled.
•Run the sc config matrixserver start= disabled command.