3.6.1 HP PolyServe Matrix Server Administration Guide (T5392-96018, August 2008)

Chapter 21: Other Matrix Maintenance 296
From the command line, use these commands to check the status of
monitors:
mx service status
mx device status
Clear an Error
After you have determined the cause for a script event, be sure to correct
the script on all servers that reported the event. You should then clear the
error. On the Management Console, select the monitor, right-click, and
select Clear Last Error. To clear an error from the command line, use these
commands:
mx service clear <vhost:port> <server> ...
mx device clear <devicename> <server> ...
Because the error is server-specific, you must clear it on each server in the
matrix (just as you had to correct the script on each server that reported a
problem).
NOTE: An error on a monitor may still be indicated after correcting the
problem with the Start, Stop, Recovery, or probe script. Errors can
be cleared only with the PolyServe Management Console or the
appropriate mx command. An error will not be automatically
cleared by the ClusterPulse process. The date and time of the
script event are available in the event log.
Monitor Activity
Service and device monitors report one of the following as their activity
status:
• (activity unknown)
• Transitioning
•Starting
• Stopping
•Inactive
•Active