3.6.0 Matrix Server Upgrade Guide (5697-7085, February 2008)

Chapter 5: Post-Upgrade Steps 38

membership partition. If a partition contains less than 1 GB, select the

partition, click Replace, and then select a new partition. If three

membership partitions are configured, the replacements can be done

one-at-a-time while the matrix is online. If only one membership partition

is configured, the matrix must be offline when the partition is replaced.

See “Manage Membership Partitions” in the PolyServe Matrix Server

Administration Guide for more information.

Recreate Notifiers

If you previously used notifier scripts, you will need to recreate the

notifiers. Matrix Server 3.6 provides three event notifier services:

• SNMP Notifier Service. This service sends SNMP notifications, or

traps, to the configured SNMP targets when the selected events occur.

• Email Notifier Service. This service sends email to specified

addresses when the selected events occur.

• Script Notifier Service. This service allows you to specify a script that

will be triggered when selected events occur. This method works in

the same way as the notifiers provided with previous Matrix Server

releases; however, you can specify only one notifier script.

For information about configuring the notifier services, see “Configure

Notifiers and View Events” in the PolyServe Matrix Server Administration

Guide.

Recreate Concatenated Dynamic Volumes

After the upgrade to Matrix Server 3.6.0, you will see alerts such as the

following for each concatenated dynamic volume:

DynvolWarn: psvXX has old device format and should be

manually upgraded.

Until these dynamic volumes are recreated, you will not be able to use the

new volume disaster recovery feature. You can continue to use

concatenation when you recreate the volume.