3.6.0 Matrix Server 3.6.0 Administration Guide (5697-7081, December 2007)

Chapter 8: Configure Dynamic Volumes 80
Copyright © 1999-2007 PolyServe, Inc. All rights reserved.
To create a dynamic volume from the command line, use this command.
You can use either spaces or commas to separate the subdevice names.
mx dynvolume create [--stripesize <4KB-64MB>] <subDeviceName ...>
The following command lists the available subdevices:
mx dynvolume showcreateopt
Dynamic Volume Properties
To see the configuration for a dynamic volume, select Storage > Dynamic
Volume > Volume Properties and then choose the volume that you want
to view. If a filesystem is associated with the volume, the Volume
Properties window shows information for both the dynamic volume and
the filesystem.