3.6.0 Matrix Server 3.6.0 Administration Guide (5697-7081, December 2007)

Chapter 4: Matrix Administration 37

Use the following command at the Command Prompt to see the software

installed on specific servers:

mx server listsoftware <server>

If the operating system uses the 64-bit architecture, x64 will be specified

in the output. Otherwise, the architecture is assumed to be 32-bit.

Start Matrix Server

By default, Matrix Server starts automatically when the system is booted.

This feature is controlled by the Startup dialog. If you do not want Matrix

Server to start when the system is booted, use the Startup dialog to

change the service from Automatic to Manual.

To start Matrix Server on a particular server, use one of these methods:

• Issue the command net start matrixserver from a command prompt.

• Use the Microsoft Management Console Services snap-in. (One way to

access the snap-in is: Start > Control Panel > Administrative Tools >

Services.) On the snap-in, start the Polyserve Matrix Server service.