3.6.0 Matrix Server 3.6.0 Administration Guide (5697-7081, December 2007)

Chapter 13: Configure Event Notifiers and View Events 159
Copyright © 1999-2007 PolyServe, Inc. All rights reserved.
Target. Enter either the hostname or the IP address of the SNMP trap
forwarding target. The trap-forwarding destination port is the IANA
registered port for snmptrap (162/udp).
Community. Enter the community string that is used to access the target.
The default is public.
Disable the SNMP trap forwarding service. This checkbox can be used
to enable or disable the service as necessary.
After configuring the new target, click the Send Test Trap button to test
access to the target.
Traps are sent as SNMP v1 traps by the server that logged the event. The
trap ID is the Matrix Server message ID.
You can change the information for an existing target by selecting it from
the SNMP Trap Forwarding Table and then clicking Edit Target. To
remove a target, select it from the table and click Remove Target.
To configure the SNMP notifier service from the command line, use this
command:
:
mx eventnotifier configuresnmp --addtarget|--removetarget
[--community <value>] <target>
To test the service, use this command:
mx eventnotifier test --snmp
Configure the Email Notifier Service
To configure the email notifier service, select the Email Notification
Settings tab. This service sends email to the specified addresses when an
event configured for the service occurs.