3.5.1 Matrix Server Upgrade Guide

Chapter 2: Single Rolling Upgrades 13

16. If you installed an HBA driver in the previous step, run the following

command to load the driver:

# /etc/init.d/pmxs load

17. Verify that the server has access to the SAN storage. Run the following

command to see a list of devices and review the output to verify that

the SAN is configured as you expect.

# cat /proc/partitions

18. Check the mount points for the PSFS filesystems on the server, and

recreate them if necessary to match the other servers.

19. Start Matrix Server on the upgraded server. Run this command:

# /etc/init.d/pmxs start

20. Re-enable the server. (Select the server on the Management Console,

right-click, and select Enable.)

21. If virtual hosts that were primary on the server are not set to fail back

to the server automatically, you may want to manually move them

back to help ensure load balancing.

22. Repeat this procedure on the server with the next-highest IP address.

The matrix upgrade is now complete.

If the PolyServe Management Console software (versions earlier than

3.5.0) is installed on client machines, the software must be upgraded to

the 3.5.1 version. See “Upgrade the Management Console on Clients” on

page 20.