3.5.1 Matrix Server Installation Guide (June 2008)

Appendix E: Configure the Matrix from the Command Line 89
Add the Remaining Servers to the Matrix
To add another server to the matrix, select Matrix > Server > New and
enter the name or IP address of the server on the New Server window.
Repeat this procedure to add the remaining servers to the matrix. The
Management Console will show that the servers are down because
Matrix Server is not yet running on them.
Start Matrix Server on the Remaining Servers
Run the following script on each server that you added to the matrix.
# /etc/init.d/pmxs start
NOTE: When Matrix Server is started on a new server, ClusterPulse
updates the SAN information on that server. During the update,
the Management Console may be unable to report SAN
information. You can ignore this; the matrix is operating correctly
and the SAN information will reappear within a few seconds.
The installation is now complete. See the File Serving Utility
Administration Guide for information about configuring the matrix.