3.5.1 Matrix Server Administration Guide

Appendix B: Error and Log File Messages 344

SCL Daemon Messages

If messages such as the following appear in the matrix log, the matrix

may not be able to start up properly. Contact PolyServe Technical Support

for assistance.

CRITICAL ERROR: Unable to fence host xxxxxxxx xxxxxxx: xxxx

(switch=xxxx)

Network Interface Messages

The PanPulse daemon generates messages about the state of the network

interfaces configured in the matrix. If you receive a message that a

network interface is down or unavailable, or that a network interface does

not meet the interface requirements, you will need to take corrective

actions.

A Network Interface Is Down or Unavailable

These messages indicate that there is a problem with the specified

network interfaces. The hardware may have failed, or a network interface

may have been taken down administratively. Check the status of the

network interface and repair it if necessary.

If PanPulse determines that one or more local interfaces are down or

unavailable, it will report messages such as the following:

Interface <ethn> address <xxx.xxx.xxx.xxx> has gone down

Interface <ethn> has gone down after a send failure

Interface <ethn> has gone down after an attempt to assign an

outbound multicast interface: <No such device>

Interface <eth_n> has been marked down because its interface

flags do not include IFF_UP

If PanPulse determines that the interfaces are down or unavailable on

another server, it will report the following:

No interfaces are responding on host <xxx.xxx.xxx.xxx>

PanPulse should receive matrix traffic at certain intervals on the active

administrative network interface. If PanPulse does not receive any traffic

during this period of time, it will report the following message:

No traffic received on active panpulse interface (<ethn>)