3.4.3 MxDB for SQL Server Installation and Administration Guide

Chapter 3: Configuration and Operation 52
Copyright © 1999-2007 PolyServe, Inc. All rights reserved.
cannot be activated on the new node, the Virtual SQL Server will fail over
to another backup node if possible.
Scripts
The Scripts tab lets you customize a SQL monitor with Post Start, Post
Stop, and Recovery scripts. You can also configure the event severity and
script ordering for the monitor.
Script Pathnames: The SQL monitor can optionally be configured with
the following types of scripts:
Recovery script. Runs after a monitor probe failure is detected, in an
attempt to restore the service.
Post Start script. Runs after the service has become active on a server. For
example, you might want a Post Start script to start a Web server.
Pre Stop script. Runs after the service has become inactive on a server.
When a monitor is instantiated, the ClusterPulse process chooses the best
server to make the service active. The Post Start script is run on this