3.4.0 Matrix Server Administration Guide

Chapter 3: Configure Servers 35

• Use the PolyServe Management Console to change drive letter

assignments. Note that the change will take place on all nodes and

may affect applications.

• Use Windows Disk Manager to change the assignments.

If you are using Windows 2000 Terminal Services to make the change,

you will need to log out and then log back in before you can use the

reassigned drive letters. The log out/log in step is not necessary for

Windows 2003 Terminal Services or for Windows 2000/2003 local

console use.

Add or Modify a Server

The above procedure describes how to add a server via the Matrix Wide

Configuration tab on the Configure Matrix window. You can also add a

new server by selecting Matrix > Add > Add Server on the PolyServe

Management Console. Then configure the server on the New Server

window.

To modify an existing server, select that server on the Servers window,

right-click, and select Properties. Then make your changes on the Server

Properties window.

Server: Enter the name or IP address of the server.

Server Severity: When a server fails completely because of a power

failure or other serious event, Matrix Server attempts to move any virtual

hosts from the network interfaces on the failed server to backup network

interfaces on healthy servers in the matrix.